Well pump and tank failures
A failed pump, switch or tank leaves the home without water until it is repaired.
Town
Burlington sits in the hills west of Farmington and north of Bristol, along Route 4 and Route 69. It is one of the most wooded towns in the area, with Nassahegon State Forest and the Sessions Woods Wildlife Management Area covering large stretches of land and a state trout hatchery on the town's back roads. The town center is small, and most homes sit on large wooded lots along winding roads and cul-de-sacs.
Because Burlington homes draw water from their own wells, much of our work here is well pumps, pressure tanks and filtration. Many larger homes also heat their water off the boiler, so we install and service indirect water heaters. We fix frozen pipes and leaks in the colder months too. We answer (860) 926-8723 24/7, send our own plumber and quote the price before work starts.

Burlington has some older farmhouses and colonials along the main roads, but most of its housing is postwar and newer: raised ranches, Capes and large colonials on wooded lots built from the 1960s onward. Most homes rely on private wells and septic systems, usually drilled wells with a submersible pump. Many larger homes have oil or gas boilers, and an indirect water heater fed by the boiler is a common setup.
A failed pump, switch or tank leaves the home without water until it is repaired.
Indirect water heaters fed by the boiler eventually leak or lose heating ability, often along with an aging boiler.
Some wells bring grit or minerals that clog fixtures and build up in tanks.
Pipes in garages, over unheated spaces and along outside walls freeze during hard cold snaps.

Most requested here
When the taps go dry on a house with a private well, the cause is usually the pump, the pressure switch or the controls. We track it down and get water flowing again.
Learn moreYour house already has a hot-water boiler, but domestic hot water comes from a tankless coil that runs lukewarm or a separate heater burning fuel on its own....
Learn moreA pressure tank that has lost its air cushion makes your well pump start every time you open a faucet. That wears the pump out, and replacing the tank is far...
Learn moreIf you like your water but not its taste, smell or grit, a whole-house filter treats it right where it enters the home. Every faucet, shower and appliance gets...
Learn moreFAQ
If your boiler is in good shape and sized for it, an indirect water heater is often a strong choice. The boiler heats a coil inside a well-insulated tank, so you get plenty of hot water without a separate burner. We check your boiler, controls and piping first and quote the full install before work starts.
Look at the pressure gauge near the tank. If it reads lower than usual, check whether a sediment filter is clogged, since that is a common cause and an easy fix. If the filter is clean, the pump, switch, tank or a buried line may be the problem. Call (860) 926-8723 and we will test the system.
Call any hour. A plumber answers and gives you a price on site before work starts.