Submersible pump failures
Pumps deep in a drilled well wear out with age and leave the house without water when they quit.
Town
Somers sits in the far north of Tolland County, bordering Enfield to the west, Ellington to the south and Massachusetts to the north. Much of the town is open farmland, horse properties and wooded hills, with Shenipsit State Forest covering the high ground on the east side. The town center sits along Route 190, and Somersville, the old mill village on the Scantic River, keeps its own small cluster of older homes on the west side of town.
Somers is rural, and most of our work here comes from homes that draw their water from their own wells. We pull and replace submersible pumps, swap failed pressure tanks and switches and install filtration when wells bring sediment or minerals. We also handle sump pumps, water heaters and frozen pipes in the cold months. We answer (860) 926-8723 24/7, send our own plumber and quote the price before work starts.

Somers housing includes old farmhouses and colonials, 1800s and early-1900s homes in Somersville and many postwar ranches, raised ranches and newer colonials on large lots. Water and sewer service is a mix, and many homes rely on private wells and septic systems. Wells in the area are mostly drilled wells with submersible pumps and pressure tanks in the basement. Basements in some areas take on water in spring, so sump pumps are common too.
Pumps deep in a drilled well wear out with age and leave the house without water when they quit.
A worn tank or pitted switch causes short cycling and weak pressure.
Some wells bring grit and minerals that clog aerators, stain fixtures and shorten water heater life.
Snowmelt and long rains raise the water table and keep sump pumps running.

Most requested here
When the taps go dry on a house with a private well, the cause is usually the pump, the pressure switch or the controls. We track it down and get water flowing again.
Learn moreA pressure tank that has lost its air cushion makes your well pump start every time you open a faucet. That wears the pump out, and replacing the tank is far...
Learn moreIf you like your water but not its taste, smell or grit, a whole-house filter treats it right where it enters the home. Every faucet, shower and appliance gets...
Learn moreA sump pump usually fails when you need it most, during a downpour or snowmelt, with the pit filling and the basement next. Most failures come down to a few...
Learn moreFAQ
Most submersible pump replacements take a few hours once the right pump is on the truck. We pull the old pump and pipe, check the wiring and pitless adapter, set the new pump at the right depth and test the system. If the tank or switch is also worn, we tell you. We quote the full price before work starts.
A whole-house sediment filter ahead of the pressure tank or just after it catches grit before it reaches your fixtures and water heater. If there are also minerals or staining, a lab water test tells us what treatment to add. We explain the options, the filter changes you can expect and the price before work starts.
Call any hour. A plumber answers and gives you a price on site before work starts.