Low pressure from galvanized pipe
Rust buildup inside old steel lines leaves second- and third-floor showers with barely any flow.
Hartford neighborhood
Parkville sits on Hartford's western edge, where Park Street meets New Park Avenue near the West Hartford line. Named for the Park River, which now runs underground in a conduit, the neighborhood grew up around the factories along Bartholomew Avenue and the rail line. Today Park Street is lined with Portuguese, Brazilian, Latin American and Vietnamese businesses, and the side streets are packed with two- and three-family homes, many owned by families who live on one floor and rent the others.
Owner-occupants in Parkville tend to fix things before they get worse, and they want to understand the job. Much of our work here is replacing old galvanized supply pipe that has rusted down to a trickle, swapping out worn shut-off valves and tracking down slow leaks behind walls. We explain what we see, show you the corroded pipe and quote the price before work starts. Our plumbers come out from downtown and answer (860) 926-8723 at any hour.

Parkville's houses were mostly built from the 1890s to the 1920s for workers at the nearby factories. They are frame two- and three-family homes on narrow lots, with a few brick apartment buildings and single-family cottages mixed in. Many still have galvanized steel supply lines, which rust from the inside and choke water pressure, plus cast-iron drains and gas boilers. MDC water is soft, but that does not stop old galvanized pipe from closing up. Basements are often low, with limited headroom for equipment.
Rust buildup inside old steel lines leaves second- and third-floor showers with barely any flow.
Galvanized fittings rust through at the threads first, often inside a wall or ceiling.
Old gate valves will not close fully, so a small repair can turn into a whole-house shutdown.
Low ceilings and narrow stairs make water heater and boiler swaps harder, so planning the route matters.

Most requested here
Galvanized steel pipe rusts from the inside out, and by the time you see brown water or a trickle at the shower, the bore is mostly scale. Replacing it is the...
Learn moreA shower that trickles, a faucet that sputters or pipes that bang when a valve closes all point to a pressure problem. The fix depends on finding where the...
Learn moreYour water bill jumped, a stain keeps spreading on the ceiling, or you hear water running when nothing is on. The leak is real, but it is hiding, and guessing...
Learn moreWhen a pipe breaks, the main shut-off is the one valve that has to work. In a lot of older houses it is a crusty gate valve that has not turned in years, or it...
Learn moreFAQ
If the upper floors have weak flow, the water runs brown after sitting or you have had leaks at threaded joints, the galvanized is near the end. Replacing the main runs and risers with copper or PEX usually brings pressure back on every floor. We can do it in stages, starting with the worst sections, and quote each stage before work starts.
In most older Parkville homes the cause is rust built up inside galvanized supply pipe, which narrows the opening over the years. A failing pressure regulator or a partly closed main valve can also be to blame. We test pressure at the meter and at the fixtures to find where it drops, then explain the repair and the price.
Call any hour. A plumber answers and gives you a price on site before work starts.