Well pump failure
When the pump in a deep well fails, the house loses all water until it is repaired.
Town
Ellington is farm country just north of Vernon, with dairy farms, open fields and long country roads stretching toward the Somers and Stafford lines. The town center along Main Street has a classic New England green, the Hall Memorial Library and old churches. Crystal Lake sits in the town's eastern hills, with seasonal cottages and year-round homes along its shore, and Route 83 and Route 140 carry most of the traffic through town.
Because so many Ellington homes are on private wells and septic systems, a big share of our work here happens at the well tank and the pump. When a pump fails, the whole house loses water, so we treat those calls as urgent. We also handle water treatment, water heaters and the usual drains and fixtures. Our plumbers cover Ellington in our own vans, answer (860) 926-8723 at any hour and quote the price before work starts.

Ellington has old farmhouses and 1800s homes near the center and along country roads, plus many Capes, raised ranches and colonials built from the 1960s onward, and newer subdivisions and condos. Many homes use private wells and septic systems, though some areas have public water and sewer. Well systems mean submersible pumps, pressure tanks and switches, and some wells bring minerals that call for treatment. Lake homes around Crystal Lake can have older plumbing from their seasonal days.
When the pump in a deep well fails, the house loses all water until it is repaired.
A tank that loses its air charge makes the pump short-cycle and wear out faster.
Iron, manganese or hardness stain fixtures and shorten water heater life.
Water lines to barns, garages and well pits freeze during hard cold snaps.

Most requested here
When the taps go dry on a house with a private well, the cause is usually the pump, the pressure switch or the controls. We track it down and get water flowing again.
Learn moreA pressure tank that has lost its air cushion makes your well pump start every time you open a faucet. That wears the pump out, and replacing the tank is far...
Learn moreOrange stains in the tub, a rotten-egg smell in the shower or white crust on every faucet tell you something is in your well water. Treatment starts with...
Learn moreNo hot water, a shower that goes cold in two minutes, or a tank making popping noises. Most of the time a water heater can be repaired, and the trick is...
Learn moreFAQ
If the pump clicks on and off every few seconds while water runs, or the pressure swings up and down at the faucet, the tank has likely lost its air charge or its bladder has failed. That short-cycling wears out the pump. We test the tank and switch and quote a repair or replacement before work starts.
Yes. We start with a water test, then recommend equipment sized to the problem: a softener for hardness, an iron filter for iron and manganese or a sediment filter for grit. We install it near the pressure tank, set it up and explain how to maintain it. We quote the price before installing.
Call any hour. A plumber answers and gives you a price on site before work starts.