Steam system problems
Banging pipes, cold radiators and low-water cutoff trips are the usual signs a steam system needs attention.
Hartford neighborhood
Frog Hollow lies just southwest of the State Capitol, with Park Street as its main commercial street and Pope Park on its western side. It was one of Hartford's first industrial neighborhoods, built to house workers at the factories along the Park River, and its brick row houses and Perfect Six apartment buildings still line streets like Lawrence Street and Babcock Street. Park Street is the heart of Hartford's Puerto Rican and Latino community, full of markets, bakeries and restaurants.
The brick buildings here are sturdy, but the pipes inside them are often original or close to it. We spend a lot of time in Frog Hollow basements working on steam boilers, cast-iron drains clogged with a century of scale and supply lines that have been patched many times. Several apartments usually share one system, so we work quickly and keep tenants informed. We answer (860) 926-8723 24/7 and quote the price before any work starts.

Frog Hollow has some of Hartford's oldest housing, much of it from the late 1800s and early 1900s. Brick row houses, Perfect Six buildings with two units on each of three floors and frame multi-family homes make up most of the neighborhood. Many buildings still heat with steam boilers feeding cast-iron radiators. Drain stacks are cast iron, laterals are often clay and supply pipe is a mix of galvanized and copper. The MDC supplies water and sewer, and like other older parts of Hartford, storm backups through floor drains are possible here.
Banging pipes, cold radiators and low-water cutoff trips are the usual signs a steam system needs attention.
Century-old drain lines narrow with scale, and clogs come back quickly after a basic snaking.
Years of piecemeal repairs leave mixed pipe and failing joints throughout a building.
Heaters squeezed into corners of old basements often have venting that needs correcting.

Most requested here
When the boiler quits on a January night, the radiators go cold fast and the pipes are next. We repair steam and hot-water boilers, from the burner to the last radiator.
Learn moreA cable punched a hole in the clog, but the drain keeps closing back up every few months. The pipe walls are coated with grease, scale or roots, and the full...
Learn moreOld cast-iron drain lines can split along the bottom, rust through at the hubs or start weeping sewer gas into the basement. We replace the bad sections before...
Learn moreWhen a pipe leaks in a three-family house, it is rarely one apartment's problem. Landlords need fast, organized repairs that keep units livable and tenants informed.
Learn moreFAQ
Banging in a steam system usually means condensate is trapped in a pipe that has lost its pitch, or the boiler water level or pressure is off. Old main vents that no longer let air out make it worse. We check the boiler, pressure settings, vents and pipe slope, then fix the cause rather than just the noise. Call (860) 926-8723 to set up a visit.
Usually, as long as we camera the line first. Jetting clears scale and grease that a cable leaves behind, which helps keep clogs away longer. If the camera shows cast iron that is thin or broken, we lower the pressure or recommend repairing that section first. We explain what the footage shows and quote the price before we start.
Call any hour. A plumber answers and gives you a price on site before work starts.